Tyke – EDC Knife Update 5

So, update #5…

We are making steady progress (which is refreshing). Since the last update I have finished milling the chamfers and pockets on the blades.

The blades were then sent for heat treating. The turnaround on this was fairly quick and we got them back in no time.

Today we pushed hard and managed to get them to the stage where we can do our final finishing/sharpening (we still have to fit the scales are this stage):

 

It is now the end of the day and it’s nice to have all the blades at this stage:

 

Getting there. Still have the scales to do as well as the holders – these should both not take too long. *fingers crossed*

Apologies for the short update – but a short update is better than no update, right? 🙂

  • Richard Banham says:

    Great to see the progress Magnus. I noticed you have launched another knife project (Flixx). I hope you are not trying to do too much at once.

  • Donald Perreault says:

    Your the man, Magnus, oh and I mustn’t forget your minions 😉 Praise to the crew for the continued effort.

  • Max says:

    Merci Magnus !!!

  • >